Aluminum Wheels

This large Alcoa front wheel below is what a aluminum wheel should look like after polishing. If yours doesn't,it probably is coated with left over polishing compound that creates a hazy look. metalwax will remove the left over polish from previous polish and give you that "clear glassy look"

Metal Wax will give you this same shine performance on all your wheels.

This wheel also polished with Metal Wax. This type wheel is difficult using compound type polishes because of the fine groves in the spokes.

With Metal Wax it's no problem. Just clean it with the cleaner we provide, then wax it. Our product is made of a soft gel . Metal Wax is wax, so there is no left over micro fine particles of rouge to hang in the groves. You get a very bright, clear, long lasting shine.

Here's another example. This wheel not only has five groves in the spokes it has a rolled rim. Very hard to polish using compounds. With Metal Wax you get a very consistent shine every time.

This solid aluminum wheel from a Harley Davidson Fat Boy is easy to polish with Metal Wax. Notice the clarity and uniform shine This wheel turns heads going down the road. more photos on the Motorcycle page

The truck wheel below on the left is a brand new wheel. It looks good until you compare it to the wheel on the right The wheel on the right is the same wheel that has been cleaned and polished with metalwax. Even a new wheel has left over buffing compounds in the pores of the aluminum.Our point in these photos is to show you how different and better your wheels look without the left over polishing compounds that every polish has except metalwax.

Our metalwax set comes with the right tools to remove this compound and the right wax to seal the wheel from shine decay which is caused by left over compounds and soap that uses the micro fine compounds to stick to your wheel.

Use metalwax and stop shine decay from snow and ice

Weatherproof your wheels

"It's fast and easy with metalwax"

Here are more before and after photos of weld racing wheels. Notice how the wheel on the left has clouded out. This is caused by left over soap that sticks to the surface every time you wash the wheel.It is important to clean the wheel first to remove this old film and any left over polishing compounds.The cleaner you get the wheel the better the shine and the longer it will last.

The photo on the right shows the wheel cleaned and polished with metalwax. Metalwax is the only wheel polish made that you can wash off the black residue in minutes with soap & water instead of hours of buffing to remove the polish required with other brands

Before and After photo of an aluminum wheel. Photo on the left shows lots of build up from brand X polishing compounds which is typical of shine decay.The same wheel on the right after cleaning and polishing with metalwax. Our product will do the same for your wheels

Before & after photo of a high end billet specialties wheel. The wheel on the left was polished with Brand X and that's the maximum shine it could achieve. Now the same wheel on the right was cleaned & polished with Metalwax products by hand in under 4 minutes. You be the judge. What shine would you rather have on your wheel?

Do not confuse our high quality reagent grade wheel cleaner with cheap spray on wheel cleaners made by Brand X manufacturers

Metal Wax is a spec'd out Billet Polish made for this type of high end wheel. Metal Wax will never leave a white film like Brand X . This wheel was polished by hand with no power balls, no buffers necessary.

Can you get this result with your present wheel polish?

If not, you better get metalwax!

Have you been a victim of the cheap spray on wheel cleaners?

Once you burned your wheels with acid it's not easy to bring them back. Metalwax is the best shot at recovery. The reason is our cleaner will actually lift the acid out of the metal to remove the white streaks. These streaks occur because the wheel coating is too thin or has pin holes where your spray cleaner went through to the metal where it was etched. You can't it get off because your polish is a liquid or paste compound that only has grinding power. With metalwax you have a cleaner that removes acid burns and a product that polishes plastic, which is the coating on your anodized wheels

"Metalwax is a better system for your wheels"

WANNA TURN HEADS WITH YOUR WHEELS ?

USE METALWAX

METALWAX -TRI PAK

This selection will provide you with all the products you will need to clean, polish and maintain all your metals. It is an exceptional value. The tri pak includes

16 ounces of Quick Spray Shine

16 ounces of metalwax polish

16 ounces of metal cleaner

INCLUDES APPLICATORS

VALUE PRICED $ 69.95

Quick Spray Shine & Metalwax are aero space AMS1650 C Type 2 & aircraft approved with spec numbers Douglas Aircraft CSD #1
Boeing cert numbers D6-17487 rev. P AMS1650 C Type 2
S M I - 05APR481